|
|
|
JG Speedfit
New ~ 15 mm Valved hose fitting
Where an application demands a higher quality valved hose assembly, this unit provides the solution and offers the same level of quality and reliability you would normally associate with John Guest Speedfit range.
|
|
As the world’s largest manufacturer of push-in pipe fittings, John Guest has been pioneering revolutionary lastics manufacturing since the early 1970’s.
Over the past 25 years, the company has established a worldwide reputation for product quality and service.
|
| JG Speedfit products are fully certified by the British Board of Agreement and approved by the Water Research Centre within the requirements of the UK Water Fittings Byelaws Scheme, and are kitemarked to BS7291 Parts 1 and 3.
Assemblies are manufactured from a high quality EPDM rubber hose with a 304 grade Stainless Steel outer braiding whilst the fittings are secured by high pressure swaging of Nickel Plated Brass or Stainless Steel ferrules.
Hoses can be manufactured to any length required. |
|
Insulation
Hoses can be pre-insulated with high quality class O insulation. All insulated hoses are fitted with end caps and have the correct vapour seal which is essential to prevent condensation build up.
WARNING: Using insulated hoses without a vapour sear invalidates any warranty. Guarantee
All hoses manufactured by Hydraquip are produced under strict control procedures and come with a 12 month guarantee against material defects. Extended guarantees are available subject to terms and conditions - full details available on request. The life expectancy of these hoses has been tested by BSRIA over a simulated period in excess of 12 years without any sign of deterioration (full report available - no13428/1 edition 2). |
|
